DESIGN & BUILD OF HOME AUTOMATION TRAINER USING MCU ESP8266 NODE MODUL BASED ON INTERNET OF THINGS (IOT)

Atmiasri; Maharani Wisudawati Swista Rani

doi:10.36456/best.vol4.no2.6060

Authors

Atmiasri Universitas PGRI Adi Buana Surabaya
Maharani Wisudawati Swista Rani Unipa

DOI:

https://doi.org/10.36456/best.vol4.no2.6060

Keywords:

IoT Learning Media, Smart Home, Node MCU ESP8266, Device automation

Abstract

The development of knowledge and technology in the world of education is currently advancing rapidly, providing many new ideas, methods and innovations in the field of technology development, especially trainers. Home automation is the
introduction of technology in a home environment to provide convenience and protection for residents by remote monitoring. The smart home modeling device based on the ESP8266 Node MCU and the Internet of Things (IoT) uses Blynk as a monitoring controller that is stored on a Virtual Private Server (VPS). This system uses relays to connect lights, sockets, and fans, the DHT11 Sensor detects humidity and temperature, the Flame Sensor detects fire, and the MQ-2 Sensor detects gas leaks. The results obtained that the average lag time for turning on the relay is about 0.12 seconds and the average turning off the relay is about 0.12 seconds, the average error of the DHT11 Sensor when detecting heat is 3.3O Celsius and when detecting cold is -28.2O Celsius, the limit for detecting fire on the Flame Sensor is a maximum of 20 cm, the limit for gas leakage is set above 200 ppm.

References

Alodokter.(2021) Covid-19. [Internet]. Available on the page http://www.alodokter.com/viruscorona (accessed June 30, 2021: 14:56).

Atmadja, M. D., Soelistiant, F. A., & Kristiana, H. M. (2016). Comparative Analysis of Circuit Arrangements in LED Lamps for Lighting. SENTIA 2016, 8(2).

Bahari, W. P., & Sugiharto, A. (2019). Design and Build of Internet of Things (IoT) Based Fire Detection Equipment (Doctoral dissertation, University of Technology Yogyakarta).

BASKORO, M. (2017). CONTROL STOP CONTACT THROUGH THE INTERNET (Doctoral dissertation, SRIWIJAYA STATE POLYTECHNIC).

Bastari, Winarno Fadjar, Akhmad Solikin, and Widodo Widodo. "Alarm Pengendali Asap Pada Ruangan Bebas Asap Berbasis Mikrokontroler Arduino." JE-Unisla 7.1 (2022): 32-35.

Chumaidy, A. (2017). COMPARISON ANALYSIS OF THE USE OF TL, CFL AND LED LIGHTS (CASE STUDY IN APARTMENT X). Sinusoid, 19(1).

Ciptadi, P. W., & Hardyanto, R. H. (2018). Application of IoT Technology on Hydroponic Plants using Arduino and Blynk Android. Journal of Informatics Dynamics, 7(2), 29-40.

Daulay, N. K., Lestari, N., & Armanto, A. (2020). Fan Speed Control Monitoring Simulation Using Web-Based Fuzzy System. Journal of Informatics and Electronic Engineering, 3(1), 66-76.

Fadli, M., & Fitriani, E. (2020). DESIGN AND CONSTRUCTION OF CIRCUIT BREAKER ON CONTACT STOP AND SWITCH DURING FLOOD BASED ON MICROCONTROLLER. In Bina Darma Conference on Engineering Science (BDCES) (Vol. 2, No. 2, pp. 96-106).

Hardyanto, R.H. (2017). Internet Of Things Concept In Web-Based Learning. Journal of Informatics Dynamics, 6(1), 87-97.

Rochman, Sagita, and Roib Mukodah. "AUTOMATIC FISH GRILLER BASED ON TEMPERATURE CONTROLLER." BEST: Journal of Applied Electrical, Science, & Technology 2.2 (2020): 33-36.

Sujiwa, A., & Hadiwikarta, O. (2020). ARDUINO UNO BASED AUTOMATIC DESIGN TO BUILD WINE DRINKING TOOL USING SOIL MOISTURE SENSOR. BEST: Journal of Applied Electrical, Science, & Technology, 2(2), 24-27.

Sujiwa, A., & Prasetyo, H. P. (2020). MEASUREMENTS ANALYSIS OF MQ-6 LPG GAS LEAK DETECTION DEVICES FOR DISTANCE FACTORS. BEST: Journal of Applied Electrical, Science, & Technology, 2(1), 6-9.

Winarno, Adi, and Mahfud Affandi. "Design and Construction of Smart House Prototype Based Internet of Things (Iot) Using Esp8266." BEST: Journal of Applied Electrical, Science, & Technology 4.1 (2022): 11-14.